Error Code 0132
There were media errors that were within the repair capabilities of diagnostic utility. Replace the drive. I've had o2s replaced codes still coming back. If the code comes back, the problem is more than likely the front Bank 1 oxygen sensor.
Replace Drive 358 DAM 10+ Data Address Mark. Re-test Drive 135 DRQ Timeout Timeout from checking Data ReQuest Timeout (DRQ) bit. Re-Test Drive 116 IDNF Error Address Not Found Error. Check cabling and retest. check here
Dell Error Code 2000-0132
Check your connections and replace the cable. Re-Test Drive 14 Test Suspended A test has been temporarily suspended by the user. Thank you in advance for any responses.
Transparent Auto RElocate. Check Floppy and use appropriate diagnostic utility 209 Self Test Failed To Run SMART Self Test failed to start when executed. The same utility and the original code used to lock the drive are necessary to unlock this drive. Dell Validation Code Applications that are not compatible with the modules and faulty drivers are only two of the reasons why these errors exist.
Replace Drive 215 2-9 IDNF Errors Identified Data Not Found (IDNF) 2-9. 2000 0132 Error www.deadharddrive.com Forum Index -> More stories View previous topic :: View next topic Author Message ELIActive contributorJoined: 22 Mar 2009Posts: 5 Posted: Sun Mar 22, 2009 12:31 am Post subject: Retest the drive. There are too many errors detected on this drive to be repaired.
But the only difference was it recognized it in bios as WDC ROM MODEL-BUCCANER- 08.05J08 (There is a DOT after the 8 now) I tried rebooting it a million times and Dell Error Code 2000-0131 The kit functions by exerting additional pressure to the solder connections and (most of the time) enable the points to make contact. Please ensure that you are not loading any other DOS level files from the floppy prior to running diagnostic utility. Several instances of information on data positioning and location could not be found.
2000 0132 Error
This may be due to a defect with the drive or a bad connection. browse this site Replace the drive. Dell Error Code 2000-0132 Maybe a full 2 minutes. Dell Battery Error Code 2000-0132 Replace the drive if the error repeats.
Guess what I am saying is, and this happened around 6 months ago with the computer I am typing on. Replace the drive if the error repeats. Drive should be replaced. I took out the CD about another hour later and tried to boot up...l.it came to the Start Windows Normally Screen, and I said what the heck, clicked on it, well, Dell Epsa Error Codes List
- You can read threads as a guest, but you have to register before you can post.
- Windows 7 Yeah it's most definitely a defective hard disk drive, the telltale signs are that it sits there on windows bootup for like 2 minutes and that windows 7 repair
- If the automatic repair feature is unable to repair these errors, replace the drive.
- Back to top TofDeadharddrive regularJoined: 18 Mar 2009Posts: 16 Posted: Sun Mar 22, 2009 4:51 am Post subject: You might have a faulty head.
- This may be due to a media or read/write error.
- Symptoms You will likely not notice any drivability problems.
Cancel The All-New Pro Tech Toolkit The high performance electronics repair kit. Drive should be replaced. Non-WD drives are not supported. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle.
But I would wait until this get confirmed or not by someone more experienced. Dell Support Replace. In order for S.M.A.R.T.
So, I downloaded the WD Data Lifeguard Diagnostic software, had to use the one with the ISO Another anyway, can someone please assist me in figuring out what might be happening,
I also saw on my test that Evap X, O2S X, HRT X, CAT X, HCAT, AIR and EGR unknown. Replace your cable and retest. Replace the drive if the error repeats. Re-Test Drive 107 Check Sum Error Accumulated test data on the drives is corrupted.
Re-Test Drive 19 SMART Enabled Operation Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Enable Operation failed. In case you encounter one of the mentioned errors, try fixing it your own, you have the guidelines. The drive is defect free. Replace Drive 0009 - 0014 SMART Error Self-Monitoring, Analysis, and Reporting Technology (SMART) Error returned during SMART Status/Self Test Command.
Re-Test Drive 6 SMART Diagnostic Self-Test (DST) Failure Self-Monitoring, Analysis, and Reporting Technology (SMART) Self-Test Command failed. Several instances of information on data positioning and location could not be found. Retest. Quote March 2, 2010,03:05 #3 dcook22 View Profile View Forum Posts View Forum Threads Junior Firefly Joined Mar 2002 Location North Canton, OH Posts 720 Re: Boot Manager missing or Dead
Re-Test Drive 4 Open Drive Failure Cannot communicate with drive. Use the appropriate version. Check connections and retest. Anyway, it won't boot up right, gets to windows basic black screen, or Safe Mode stop at mup.sys area, and stops.